Add to Cart
Description
1. Scan function:
1. Input ID: 3417
2. Press Set button, and then a button.
3. Press key to show: COUNTER: 1 (expressed as a number of launches can be arbitrary choice 1-9 times)
FLOW: ON-UP (open the door, up key)
4. Press stop button, return 0.
5. Press Manual button.
6. Press key five times, indicating: # 2262 T24
000,000,001,000
7. Press manual button once, the cursor in the T24 T-word flash.
8. Press key to adjust matching resistor, the machine factory default for the 2.4M ohm matching resistor, and now basically is not used in mainland China (mainland generally 4.7M ohm, and the case of other matching resistor can be self-tuning, down to the lower keys are matched resistance)
9. Press manual button three times, the cursor moved to the lower right corner of the screen, this time choose to scan individual password.
10. Press 7 key to scan the first 8 code, (that is, master password, scan time to 60 minutes or so)
11. Press 8 key scan 4 yards, (that is, key-bit code, scan time to 10 minutes or so)
12. Press 9 key is the full code scan (full scan to be 2 hours or so)
13. To any of the above mentioned 7,8,9 pressed a button when the machine immediately began scanning motion, please wait patiently sweeping response to a time when the receiver, (such as soon as the receiver ring, lights flash look, receiver inside the following Electric jump about, vibration it), immediately press the stop button once, do not press the second, according to the second is the full return 0, the scanned data will not remember.
14. Press into key, then keys 5 keys to a any one key, the existence of just sweep to the yards you want to key on the machine is called three times, says it has just scanned the password stored keys to a button on the key five
15. If you press the stop button too late can be inverted back to the receiver and then the reaction time is to find the password. (Preferably by sweeping out the password to write it down for reference)
16. Press stop button return 0.
17. Press Remove button.
18. Button 1 to button 5 are adjustable to any one key out of the remote control just saved passwords, this time the scanner is quite a remote control.
19. If the Division I all-English tie in remote replicator, you can store the remote control device transferred to a remote control up, method is to put the whole front of the scanner in Chinese remote control sensor area on the receiver replicator,
Reading function:
1. Boot type ID: 3417
2. Press accept button, display READ
3. The remote sensing area on any one pressing the remote control button, the receiver after the show after the host calls out the remote control of the internal code data, please check the remote control if you can not show whether the normal use.
4. Press the stop key to exit.
